hello friends as you mentioned before those codes i tried to do on my polo which has module: 6Q0 959 433F
and it had the values with
04361 138
04362 138
04363 138
and when i tried to read or write values in driver and all other windows values it give an error in reading such as 08269, 08224 ... etc
so what is the problem here ?
The prerequisite is
- software VDC-Pro PW: G4SE (MS-DOS) to rewrite the EEPROM
-
select serial interface and portable computer with the appropriate COM interface STG 46, login: enter 19283.
With function 26 read EEPROM with 27 write EEPROM.
Change the values in EEPROM as follows (the changed values are in brackets): Enable
control unit for window via FFB:
04361: subtract 8 from what is there (old: 10, new: 2) or (old: 138 , new: 130)
04362: subtract 8 from what is there (old: 10, new: 2) or (old: 138, new: 130)
04363: subtract 8 from what is there (old: 10, new: 2) or (old: 138, new: 130)
driver
window: 08224: 16 add (old: 79, new: 95)
08269: 16 add (old: 79, new: 95)
08314: 16 add (old: 79, new: 95)
Passenger window:
12320: 16 add (old: 79, new: 95)
12365: 16 add (old: 79, new: 95)
12410: add 16 (old: 79 , new: 95)
rear left window (only 4-door Polos):
16416: 16 add (old: 201, new: 217)
16461: 16 add (old: 201, new: 217)
16506: 16 add (old: 201 , new: 217)
rear right window (only 4-door Polos):
20 512: 16 add (old: 201, new: 217)
20557: 16 add (old: 201, new: 217)
20602: add 16 (old: 201, new: 217)
end communication (06)
ignition off, test. Finished!
On vehicles with a sliding roof, the roof closes after the windows are closed.
The sunroof doesn't open, I would say that doesn't matter the main thing is the windows.
My control unit All which is installed,
address 46: Comfort system
part number: 6Q0 959 433 E
Component: 3P comfort unit 0001
Coding: 00064